Removing The Sub Board - Epson Perfection V700 Photo Service Manual
Hide thumbs
Also See for Perfection V700 Photo:
- User manual (157 pages) ,
- Notices and warranty (13 pages) ,
- Specifications (4 pages)
Table of Contents
Advertisement
EPSON Perfection V700 Photo
4.2.3
Removing the SUB Board
1. Remove the Upper Housing.
2. Remove the C.B.P. M3 x 8 screw that secure the SUB Board Unit,
and remove it.
C.B.P. 3x8 (7±1 kgf.cm)
Figure 4-11. Removing the SUB Board Unit
3. Disconnect the Panel Board Connector CN1 and the SUB Board
Connector CN2 connected to the SUB Board.
Panel Board Connector
(CN1)
Figure 4-12. Removing the SUB Board Unit (1)
Disassembly / Assembly
See Section 4.2.2 on page 40.
SUB Board Unit
SUB Board Connector
(CN2)
SUB Board
4. Remove the SUB Board from the SUB Board Holder.
SUB Board
Notch and Dowel
Figure 4-13. Removing the SUB Board Unit (2)
When installing the SUB Board to the Sub Board
Holder, match the notch and tab as shown in
4-13.
Route the SUB Board Connector cable through the
notches on the Lower Housing as shown below.
Figure 4-14. Routing the SUB Board Connector Cable
Disassembly Procedure
Revision A
SUB Board Holder
Figure
Notches
43
Hide quick links:
Advertisement
Table of Contents
