Removing The Driven Pulley Unit - Epson Perfection V700 Photo Service Manual

Hide thumbs Also See for Perfection V700 Photo:

Table of Contents

EPSON Perfection V700 Photo

4.2.8

Removing the Driven Pulley Unit

1. Remove the CR Drive Belt from the Driven Pulley.

See Step 1 to Step 8 in Section 4.2.7

2. Remove the two C.P.F.P. M3 x 8 screws that secure the Driven

Pulley Unit, and remove the Driven Pulley Unit and the Driven

Pulley Spring.

3. Remove the Driven Pulley Spring from the Driven Pulley Unit.

Driven Pulley Unit

C.P.F.P. M3x8

(7±1 kgf.cm)

Figure 4-33. Removing the Driven Pulley Unit

Disassembly / Assembly

4. Remove the E-ring and then remove the Driven Pulley from the

Driven Pulley Spring

Rib of the Driven

Pulley Holder

A D J U S T M E N T

Disassembly Procedure

Driven Pulley Unit.

E-ring

Driven Pulley Holder

Figure 4-34. Removing the Driven Pulley

Insert the Driven Pulley Spring into the Lib of the Driven

Pulley Holder.

Whenever the Driven Pulley Holder is replaced, G-26 grease

R E Q U I R E D

must be applied to the specified points.

See Figure 6-1 on page

Revision A

Driven Pulley

70.

Table of Contents

Show Quick Links

Table of Contents