Table of Contents
Advertisement
Turning the Power On/
Off
Turn the Power On
Turn on the AIT library power, then turn on the host
computer power.
1
Press the power switch on the rear of the library.
The library can only be turned on by pressing the
power switch on the rear.
The initialization operations appear on the LCD
display.
Initialize completed
Inventory 83
If the date and time screen appears at the end of the
initialization process, you can change the library's
date and time settings.
Caution
By default, the library is set to read bar codes. If you
use cartridges without bar code labels with this
setting, initialization after turning on the library
becomes unusually long. For details about how to
set the library to read bar codes, see "Setting the
Bar Code" in "Basic Usage" in chapter 3, in the
"Operating Instructions" (PDF).
8
Turning the Power On/Off
2
If you want to change the date and time, press the
[ENTER] button. If you do not want to make
changes, press the [CANCEL] button.
Jan/01/2001
12:00:50
Set the Date and Time
if necessary
[ENTER] to set
[CANCEL]to exit
• For details about the date and time settings, refer
to "Setting the Date and Time" in "Installation"
chapter 2, in the "Operating Instructions" (PDF).
• You can change settings so that the date and time
screen does not appear after startup. For details,
see "Disabling the Display of the Date and Time
Screen" in "Basic Usage" in chapter 3, in the
"Operating Instructions" (PDF).
Notes
• The date and time cannot be updated when the
AIT library is off. For this reason we recommend
that you set the date and time each time that you
turn on the library.
• If the library is left idle for five minutes, the status
display appears automatically.
Once the library is started, the following status
screen appears.
READY
1
5
D2
D1
9 10 11 12
AIT3
AIT3
13 14 15 16
READY
READY
3
Wait at least 15 seconds after pressing the library's
power switch before turning on the host computer.
When you are done, go to "Initial Setup" in
"Installation" chapter 2, in the "Operating
Instructions" (PDF).
Notes
• If the host computer is turned on too soon after turning
on the library, the host computer may not detect the
library's SCSI IDs. Wait at least 15 seconds after
turning on the library before turning on the host
computer.
• If the library does not work as above, refer to
"Troubleshooting" in the "Appendix" chapter, in the
"Operating Instructions" (PDF).
2
3
4
6
7
8
Advertisement
Table of Contents
