Table of Contents
Advertisement
Turn the Power Off
1
Press the power standby switch on the front panel at
least 3 seconds.
When the power standby switch is pressed, the
internal mechanism moves to the predetermined
position.
When the following message appears, the library
does not turn off automatically.
Shutdown
Wait a minute
+++
2
When the following message appears, turn off the
library by pressing the power switch on the rear.
Ready for shutdown
Press
the power switch
on the rear of the
Library
Caution
• You can turn off the library by pressing the power
switch on the rear of the library, but we urge you to
perform the procedure above to turn off the library.
• ·After turning the AIT library off, wait at least 10
seconds before pressing the power switch on the rear
of the library to turn it back on. If you turn on the
library within 10 seconds of turning it off but it does
not start, press the power switch again to turn the
library off, and wait at least 30 seconds before
attempting to turn it on again.
Note
To avoid pressing the power standby switch by accident,
you can disable the power standby switch. For
information on how to disable the switch, refer to
"Disabling the Buttons on the Front Panel" in "Basic
Usage" in chapter 3, in the "Operating Instructions"
(PDF).
+++
What's next?
Read the Operating Instructions, install cartridges, make
network connections as necessary, then make settings
required to use the library. Procedures for making
settings and using the library are given in the Operating
Instructions (PDF) together with usage precautions and
other necessary information. Please be sure to read it.
9
What's next?
Advertisement
Table of Contents
