Poe Port Settings - D-Link Xstack DES-3528 Series Reference Manual
Stackable fast ethernet switch web ui
Hide thumbs
Also See for Xstack DES-3528 Series:
- Cli reference manual (605 pages) ,
- Reference manual (367 pages) ,
- User manual (322 pages)
Table of Contents
Advertisement
xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch Web UI Reference Guide
The following parameters can be configured:
Parameter
Unit (1, 3-5)
Power Limit (37-
370)
Power Disconnect
Method
Legacy PD
Click the Apply button to implement changes made.
Click the Refresh button to update the display section of this page.
PoE Port Settings
To view the following window, click System Configuration > PoE > PoE Port Settings, as shown below:
Figure 2-14 PoE System Settings window
Description
Select the unit to configure. Tick the All check box to select all units.
Sets the limit of power to be used from the Switch's power source to PoE ports. The user
may configure a Power Limit between 37W and 370W for the DES-3528P/DES-3552P.
The default setting is 370W.
The PoE controller uses either Deny Next Port or Deny Low Priority Port to offset the
power limit being exceeded and keeps the Switch's power at a usable level. Use the
drop-down menu to select a Power Disconnect Method. The default Power Disconnect
Method is Deny Next Port. Both Power Disconnection Methods are described below:
Deny Next Port - After the power limit has been exceeded, the next port attempting to
power up is denied, regardless of its priority. If Power Disconnection Method is set to
Deny Next Port, the system cannot utilize out of its maximum power capacity. The
maximum unused watt is 19W.
Deny Low Priority Port - After the power limit has been exceeded, the next port
attempting to power up causes the port with the lowest priority to shut down so as to
allow the high-priority and critical priority ports to power up.
Use the drop-down menu to enable or disable detecting legacy PDs signal.
21
Advertisement
Table of Contents
