Table of Contents
Advertisement
Installation
Technical data
– Delivery specification: dryer, instructions for installation and use, woollens basket
(depending on model).
– Check dryer for transport damage.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
Setting up the dryer
Take all accessory parts
1.
– The appliance plug must always be accessible.
out of the drum.
The drum must be empty.
– Ensure that the appliance is installed on a clean, level
and solid surface.
– Keep the cooling grille at the front of the dryer
unobstructed.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
Do not remove the threaded feet under any
circumstances.
Do not set up the dryer behind a door or sliding
door as this may obstruct or prevent the dryer door
from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Clean and level
Make sure that the air
inlet remains unobstructed
Mains connection
2.
see safety instructions
Page 11.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
– The mains voltage and the voltage shown on the rating plate (
Page 9) must correspond.
– The connected load and necessary fuse protection are specified on the rating plate.
Do not operate the dryer if
Frost protection/transport
there is a danger of frost.
Preparation
Optional accessories
1. Empty the condensation container
page 4.
2. Select any programme using the programme selector.
WTZ
3. Press the
Start/Stop button
condensation is pumped into the container.
1110
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
WTZ
11310
WTZ
10290
8
7
What to do if ...
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
If you cannot rectify a fault yourself, please contact our after-sales service. We will always find
an appropriate solution and will avoid unnecessary visits by engineers. Trust the expertise of
Weight
approximately 45 kg
the manufacturer and rest assured that the repair will be carried out by trained service
Max. capacity
8 kg
technicians using original spare parts. The contact details of your local after-sales service can
be found in the enclosed after-sales service directory, or by calling one of these numbers:
Condensation container
4.2 l
– GB 0844 8928979
Connection voltage
– IE 01450 2655
Connected load
When contacting the after-sales service, please quote the appliance's product number (E no.)
Fuse protection
see appliance rating plate
and production number (FD) (see the inside of the door).
Set the programme selector to Off and remove the appliance plug from the socket.
Ambient temperature
The
Start/Stop indicator
Product number/
lamp does not light up.
Production number
The Container and
You can find the rating plate on the back of the dryer.
Stop indicator lights are
Consumption rates
These are guide values determined under standard
flashing.
conditions. Fluctuations up to 10% are possible.
The Filter and
indicator lights are flashing.
Spin speed in rpm
Drying time
Energy
(residual moisture)
in min.**
consumption
Dryer does not start.
in kWh**
Cottons 8 kg
10 A
10 A
Cupboard Dry*
1400 (approx. 50 %)
131
3.74
Water is running out.
1000 (approx. 60 %)
148
4.49
800 (approx. 70 %)
165
5.17
The door opens by itself.
Iron Dry*
1400 (approx. 50 %)
109
2.24
The required degree of
1000 (approx. 60 %)
126
3.44
dryness was not achieved or
800 (approx. 70 %)
143
3.86
the drying time was too long.
Easy-Care 3.5 kg
1000
45
1.05
Cupboard Dry*
800 (approx. 40 %)
48
1.35
600 (approx. 50 %)
60
1.65
*Test program according to DIN EN 61121.
**The values may differ from the those specified depending on the type of fabric, mixture of
laundry to be dried, residual moisture in the fabric and loading capacity.
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum is illuminated after the door is opened or closed, and also after the programme is
Laundry damp.
started. It goes out automatically. Replacing the bulb
Page 10.
(order from the after-sales service using the order number)
The moisture content of the room
Connection fittings for condensation outlet
has increased significantly.
The condensation is conveyed directly via a hose.
Mains failure.
Washer-dryer stack connection set
The dryer can be placed on top of a suitable washing machine with the same width and depth
One or more indicator lights for
to save space. This connection set must always be used to secure the dryer to the washing
programme status are
machine. With pull-out worktop: WTZ 11300.
flashing.
Installation underneath the worktop
Risk of electric shock!
The interior light is not working
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
(depending on model).
9
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– In rooms inside the house.
dryer...
– To dry fabrics.
The dryer must
– Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
Mains plug plugged in?
– Remove all objects from pockets.
Programme selected?
Make especially sure that cigarette lighters are removed as they constitute an
explosion hazard.
Start/
Empty the condensation container.
– Do not lean or sit on the door
If featured, check hose for condensation outlet.
Installation
– Secure loose cables
Start/Stop
Clean the fluff filter and/or air cooler under running water
– Do not operate the dryer if there is a risk of frost.
Page 4/6.
Mains
– Connect the dryer according to specifications to an AC earthed socket, as
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
Start/Stop button selected?
– The cable cross-section must be sufficient.
Door closed?
Programme set?
– Only use earth-leakage circuit breakers with the following symbol:
Ambient temperature greater than 5 °C?
– The appliance plug and socket must be compatible.
Align dryer horizontally.
– Do not use multiple plugs/couplings and/or extension cables.
– Do not hold the appliance plug with wet hands
Clean air cooler seal.
– Never pull the appliance plug out of the socket by its cable.
Push the door closed until you hear it engage.
– Do not damage the mains lead
Clean the fluff filter and/or air cooler under running water
Operation
– Only load the drum with laundry.
Page 4/6.
Check the contents before you switch the dryer on.
Empty condensation container
Page 4.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Check water outlet (if featured).
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
Ambient temperature higher than 35 °C
airing.
cleaning solvent, etc.)
Air inlet may be blocked
keep unobstructed.
– Dust (e.g. coal dust, flour) poses a danger: do not use the dryer
explosion hazard.
Was an unsuitable programme selected?
Page 7.
Has the dryer been installed with sufficient space on all
– Do not put laundry containing foamed material/rubber in the dryer
sides? Ensure that air can circulate.
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
Fine layer of scale on the moisture sensors
Clean the
moisture sensors
page 6.
– Switch off the dryer once the programme has ended.
– Condensation is not drinking water and may be contaminated with fluff.
Use the next drying programme up or use the timer
programme as a supplement
Page 7.
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Repairs must only be carried out by the after-sales service.
Warm laundry feels damper than it really is!
– Do not use the dryer if the mains cable is defective. To avoid danger, only
Make sure the room is sufficiently ventilated.
have the defective mains cable replaced by the after-sales service.
Air inlet blocked?
keep unobstructed.
– Always pull the mains plug out of the socket before changing the bulb for the
Ensure that the air cooler has been inserted.
interior light
risk of electric shock.
Remove laundry from the dryer immediately and spread out.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
This allows the heat to dissipate.
– Dryer: pull out the appliance plug, then cut off the mains cable from the
Disposal
Page 4/6.
Clean filter and air cooler
appliance.
Check installation conditions
Page 8.
Dispose of at municipal waste disposal facility.
Switch off, leave to cool down, switch on again, restart
– Packaging: do not leave children alone with packing parts
programme.
risk of suffocation.
Pull out the appliance plug, remove the cover cap in the
– All materials are environmentally sound and can be reused. Dispose of in an
interior above the door (use Torx 20 screw driver) and
environmentally-responsible manner.
replace the bulb. Close the cover cap.
Never operate the dryer without a cover cap.
10
risk of tipping.
tripping hazard.
Tumble dryer
risk of electric shock.
risk of electric shock.
fire/explosion hazard.
Instructions for
installation and use
elastic
Observe the safety instructions on page 11.
Read these instructions before operating the dryer.
11
en
Advertisement
Table of Contents
