Recycling The Clippings; Starting The Engine; Stopping The Engine; Using The Self-Propel Drive - Toro 20792 Operator's Manual
53cm super recycler lawn mower
Hide thumbs
Also See for 20792:
- Manual (120 pages) ,
- Operator's manual (24 pages) ,
- Service manual (144 pages)
Table of Contents
Advertisement
Starting the Engine
1. Pull the blade control bar to the handle (Figure 13).
2. Pull the recoil start handle (Figure 14).
Note: If the mower does not start, contact an
Authorized Service Dealer.
Using the Self-propel Drive
Self-propel models only
To operate the self-propel drive, simply walk with your
hands on the upper handle and your elbows at your
sides, and the mower will automatically keep pace with
you (Figure 15).
Figure 13
Figure 14
Figure 15
Stopping the Engine
Release the blade control bar (Figure 16).
Important: When you release the blade control
bar, the blade should stop within 3 seconds. If
it does not stop properly, stop using your mower
immediately and contact an Authorized Service
Dealer.
Recycling the Clippings
Your mower comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before recycling the clippings.
Important: Ensure that the rear discharge plug
is locked in place. To lock the plug: Raise the
discharge deflector (Figure 17), firmly push the
plug in until it snaps into place behind the tabs, and
rotate the lever on the plug to the left (Figure 18).
1. Discharge deflector
9
Figure 16
Figure 17
2. Rear discharge plug
Advertisement
Table of Contents
