Table of Contents
Advertisement
Status LED
The LED indicates the status of the Network Camera.
Item
LED Status
1
Steady
Red
Red
LED off
2
Steady
Red
+ blinking
1 sec and off for another)
Steady
Red
+
Green
3
Blinking
Red
every 0.15 sec. + Blinking
(Red
LED on for 0.15 sec. and
off for another)
4
Blinking
Red
every 0.15 sec. + blinking
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Occasionally
resetting the system can return the camera to normal operation. If the system problems remain
after resetting, restore the factory settings and install again.
Reset:Hold for about 3 seconds and release the recessed reset button with a paper clip or small
object. Wait for the Network Camera to reboot.
Restore:Press and hold the recessed reset button until the status LED rapidly blinks. It takes
about 10 seconds. Note that all settings will be restored to factory default. Upon successful
restore, the status LED will blink during normal operation.
Restoring the factory defaults will erase any previous settings.
Green
every 1 sec.
(Green
LED off
Green
Green
LED on for 1 sec. and
Green
every 0.15 sec Restoring defaults
Description
Power on and system booting
Powered off
LED on for
Network heartbeat
Network disconnected
every 1 sec.
Upgrading firmware
15
Advertisement
Table of Contents
