Table of Contents
Advertisement
3.
Floppy disk drive connector (34-1 pin FLOPPY)
This connector is for the provided floppy disk drive (FDD) signal cable. Insert
one end of the cable to this connector, then connect the other end to the
signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
STRIKER II EXTREME
STRIKER II EXTREME/
STRIKER II NSE Floppy disk drive connector
4.
USB connectors (10-1 pin USB 78; USB 910)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
STRIKER II EXTREME
STRIKER II EXTREME/
STRIKER II NSE USB2.0 connectors
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the USB cable to ASUS �-Connector (USB, blue) first, and
then install the Q-Connector (USB) to the USB connector onboard.
2-34
FLOPPY
PIN1
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
USB78
USB910
PIN 1
PIN 1
Chapter 2: Hardware information
- Quick Links:
- Motherboard Overview
- Motherboard Layout
Hide quick links:
Advertisement
Table of Contents
