Configuring Wlan Settings - D-Link DWL-3500AP Configuration Manual

Unified wired & wireless access system

Hide thumbs Also See for DWL-3500AP:

Table of Contents

Switch is 1518 bytes. Packets that use the L3 tunnel have an extra 20 bytes in the header

for encapsulation. To support these larger frames, you can increase the MTU size on all

intermediate ports and WLAN switch ports. The AP can transmit and receive frames of

up to 1542 bytes on the LAN port

If you use tunneling only for IP telephony, or if you set the MTU size on all wireless

clients that use tunneling to 1480, you do not need to increase the MTU size in the

network.

The following example shows how to change the MTU size on port 0/1 to 1542 bytes.

You will need to repeat the steps for port 0/24. Also, make sure the port on the

"customer" L3 device where AP2 is attached has an MTU size of at least 1542.

1. From the LAN tab, access the Administration > Port Configuration > Port

Configuration page.

2. From the Slot/Port or Unit/Slot/Port field, select the port to configure from the drop-

down list, or select All to configure all ports.

3. Enter 1542 as the MTU size in the Maximum Frame Size field.

4. Click Submit to apply your changes to the running configuration.

Configuring WLAN Settings

All of the features you configure in this section are within the WLAN tab on the D-LINK

Wireless Switch.

Table of Contents

Show Quick Links

Table of Contents