Apply The Ap Profile; Save Configuration; Device Connections - D-Link DWL-3500AP Configuration Manual

Unified wired & wireless access system

Hide thumbs Also See for DWL-3500AP:

Table of Contents

Apply the AP Profile

Because the AP profile that the APs use has changed and you have not disconnected AP1,

you can manually re-apply the AP profile settings in order to update it with the new L3-

Tunnel network. The new profile will automatically be applied to AP2 after you connect

it to the L3 device and the D-LINK Wireless Switch discovers and validates it.

1. To apply the updated AP profile, access the Administration

Configuration

2. Select the check box next to Profile1 – Default.

3. Click Apply to apply the new profile to AP1.

Save the switch configuration.

This section outlines the connections needed between the Wireless Switches and the APs. At this

point, all the devices are ready to be connected. After the switch discovers the APs, they will

become managed since the MAC addresses of the APs were added to the Valid AP database in

Scenario 1.

4. Make sure AP1 is connected to port 1 of the switch

5. Connect port 0/24 to a port on the "customer" L3 device in the 172.17.5.0 network.

6. Connect ports 0/22 and 0/21 to the FTP/Audio/Video devices.

7. Connect AP2 to a port in the 172.168.6.0 network on the "customer" L3 device.

8. Wait about 60 seconds and click Monitoring

Points to make sure that both APs are managed by the switch.

AP Profiles page under the WLAN tab.

Advanced

Access Points

Managed Access

Table of Contents

Show Quick Links

Table of Contents