Process Unit; Pre-Exposure Lamp - Canon imageRUNNER 7095 Service Manual

Table of Contents

7.10.1.3 Mounting the Process Unit

Keep the following in mind when mounting the

process unit [1] to the slide rail:

1) Be sure to match the notch [2] found at the tip

of the left slide rail against the front plate [3] of

the process unit.

2) Be sure to match the bend [4] at the front of the

right slide rail against the front plate [3] of the

process unit.

Waste toner can drop on the duplex unit when the

process unit is removed. After mounting the proc-

ess unit. be sure to slide out the duplex unit and

remove the waste toner.

7.10.2.1 Removing the Pre-Exposure

1) Open the front cover.

2) Slide out the process unit.

Cover the drum with A3 paper or the like when

you have slid out the process unit.

3) Disconnect the connector [1], and remove the

two screws [2]; then, detach the preexposure

4) Remove the three screws [1], and detach the

pre-exposure holder [2]; then, detach the pre-

exposure lamp [3].

Table of Contents