Asus M2N-SLI Hardware User Manual page 50
Asus computer hardware user manual
Hide thumbs
Also See for M2N-SLI:
- User manual (146 pages) ,
- Quick start manual (41 pages) ,
- User manual (44 pages)
Table of Contents
Advertisement
Connect the right-angle side
of the SATA signal cable to the
SATA device or you may connect
the right-angle side of the SATA
cable to the onboard SATA port
to avoid placement conflict with
huge graphics cards.
4.
JMicron JMB363
This connector is for a Serial ATA signal cable. This connector supports
a Serial ATA hard disk drive that you can configure for RAID through the
onboard Serial ATA RAID controller.
The JMicron JMB363 controller item in the BIOS is set to [IDE] by default,
allowing you to enable the hot-plug function for the external device. Set to
[AHCI] to use the connectors to build a RAID set. See section "4.4.7 Onboard
Device Configuration" for details.
M2N-SLI DELUXE
M2N-SLI DELUXE SATA RAID Connector
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cables and installed Serial ATA hard disk
drives; otherwise, you cannot enter the JMicron
BIOS setup during POST.
2-2
Serial ATA RAID connector (7-pin SATA_RAID1)
®
R
right angle side
SATA_RAID1
JMB363 RAID utility and SATA
®
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
