Installing A Usb Embedded Hypervisor Flash Device - IBM System x3750 M4 Type 8722 Installation And Service Manual
Hide thumbs
Also See for System x3750 M4 Type 8722:
- Product manual (45 pages) ,
- Installation and service manual (882 pages)
Table of Contents
Advertisement
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 116.
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 21) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 36).
4. Locate the USB (hypervisor) connector on the system board in which you want
5. Make sure that the lockbar on the USB (hypervisor) connector is in the unlock
6. Align the USB flash device with the connector on the system board and push it
7. Slide the lockbar up to the locked position until the lockbar is seated firmly.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 116.
100
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
"Installation guidelines" on page 33.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
Note: You might have to remove the PCIe riser-card assembly to access the
USB (hypervisor) connectors.
to install the flash device (see "System-board internal connectors" on page 26
for the location of the connectors for the embedded hypervisor USB flash
device).
position (down).
into the connector until it is firmly seated.
USB Hypervisor key
Lockbar
Advertisement
Table of Contents
Troubleshooting
