Removing The System Board - IBM System x3750 M4 Type 8722 Installation And Service Manual
Hide thumbs
Also See for System x3750 M4 Type 8722:
- Product manual (45 pages) ,
- Installation and service manual (882 pages)
Table of Contents
Advertisement
10. Turn on the peripheral devices and the server.
Removing the system board
Before you remove the system board from the server, take the following steps to
save data, firmware, and configuration data:
v Record all system configuration information, such as IMM IP addresses, vital
v Using the Advanced Settings Utility (ASU), save the system configuration to
v Save the system-event log to external media.
Note: When you replace the system board, you must either update the server with
the latest firmware or restore the pre-existing firmware that the customer provides
on a CD or DVD image. Make sure that you have the latest firmware or a copy of
the pre-existing firmware before you proceed.
To remove the system board, complete the following steps:
280
System x3750 M4 Types 8722 and 8733: Installation and Service Guide
3. Reinstall the DIMMs and heat sinks (see "Replacing a memory module" on
page 224 and "Replacing a microprocessor and heat sink" on page 274).
4. Reinstall the microprocessor air baffles, if you removed them earlier.
5. Rotate the tray handle down until the tray is seated firmly and the handle is
locked in place.
6. Slide power supply 2 back into the server.
7. Reinstall the cover (see "Replacing the server top cover" on page 207).
8. Slide the server into the rack.
9. Reconnect the power cords and any cables that you removed.
product data, and the machine type, model number, serial number, Universally
Unique Identifier, and asset tag of the server.
external media.
Tray handle
Microprocessor
and memory
expansion tray
Power supply 2
Advertisement
Table of Contents
Troubleshooting
