Table of Contents
Advertisement
Pouring Liquid Rinse Agent into the Dispenser:
Use the recommended amount of rinse agent for your wash loads. The rinse agent
dispenser is located next to the detergent dispenser. During the wash cycle, it
automatically releases a preset amount of rinse agent during the last rinse cycle.
When the dispenser is full, the see through rinse agent level indicator will be dark.
When it is empty, it will be clear which means you need to pour in more.
Note: A full dispenser should last approximately one month.
If you want to adjust the amount of rinse agent dispensed, the dispenser has 1 to 6
levels that you can adjust to. Simply rotate the dial to your desire settings.
Checking Water Temperature:
• Incoming water must be between at least 120°F / 49°C and at most 50°F / 66°C in
order to clean effectively and prevent damage to your dishware.
Note: The minimum incoming temperature must be at 120°F/49°C in order for the
detergent to dissolve properly.
If you are unsure of the temperature of your hot water:
1. Simply open the hot water faucet and let it run for a minute and fill a glass.
2. Take a thermometer and check the temperature of the water.
3. If the temperature is below 120°F / 49°C, then you need to adjust the water
temperature on your water heater in order to maintain that temperature level.
Overflowing Protection:
• In case the water level rises above the highest acceptable point; the security
pressure switch will activate the drain pump automatically.
The Filtration System
For your convenience, the three level filtration system is conveniently located inside
the dishwasher tub beneath the lower rack and consists of a Main Filter, Coarse Filter
and Fine Filter.
14
- Quick Links:
- Maintenance Service and Trouble Shooting
Hide quick links:
Advertisement
Table of Contents
