Brother DCP130C Service Manual page 143
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
(9) Place the scanner cover upside down.
(10) To prevent the scanner cover support and damper from getting broken, remove them from the
scanner cover as follows.
Release the lock arm of the scanner cover damper from the scanner cover and pull out the
damper in the direction of arrows shown below. The scanner cover support also comes off.
Lock arm
CIS motor harness
Assembling Notes
• Route the CIS motor harness, document front and rear sensor harnesses*, ADF motor harness*
and grounding wire* as shown below and on the next page.
• If you replace the scanner cover, check the CIS type (Canon, Rohm, or Lite-On) printed on the
CIS bar code label on the new scanner cover and enter it to the EEPROM (Function code 59),
referring to
Chapter 9, Section 9.4.12.
After that, acquire the white level data and set the CIS scanner area (Function code 55), referring
to
Chapter 9, Section 9.4.10.
DCP750CW
Route the CIS motor harness
on this side.
Scanner cover support
Scanner cover damper
(Rear)
CIS flat cable
Document front sensor harness*
Document rear sensor harness*
Grounding wire*
ADF motor harness*
CIS motor harness
(Rear)
Upper cover
Main PCB
6-10
*For models with ADF
Scanner cover
(placed upside down)
(6_09)
(*For models with ADF)
(6_10_750CW)
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
