Brother DCP130C Service Manual page 172
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
Assembling Notes
• When securing the power supply PCB, tighten four screws in the order of
shown on the previous page.
• Secure the power cord to the two holes provided in section "Y" (shown on the previous page) of
the lower MJ/PS shield with a cable tie. After that, route the power cord through the cable guides
as shown below.
• When mounting the power supply shield on the lower MJ/PS shield, insert three tabs into three
slits. Make sure that section "X" of the lower MJ/PS shield is fitted over the power supply shield.
(See the previous page.)
• When mounting the MJ/PS shield box, route the power supply harness through the U-shaped
cutout (shown on
After mounting the MJ/PS shield box, route the power supply harness through the channel as
shown below.
(Paper feed motor harness)
(PF encoder/registration
sensor harness)
Power supply shield
Power supply PCB
Power supply harness
page
6-37) in the lower MJ/PS shield.
(Carriage motor harness)
Top view
Ferrite core
Cable guide
Power cord
Cable guides
Main PCB
Power supply harness
Channel
6-39
,
,
(6_39_1)
Lower cover
(6_39_2)
Confidential
and
as
Advertisement
Chapters
Table of Contents
Troubleshooting
