Brother DCP130C Service Manual page 184
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
• After mounting the flat cable support plate, pass the ink supply tubes between the tube/cable
guide and the lower cover and then through the bent section of the tube support wire as shown
below.
Bent section of
tube support wire
Flat cable support plate
• After mounting the head cover, set the CR encoder strip so that the
(carriage motor side) and the
Hook the left end of the strip on the CR encoder strip support first, pass it through the CR
encoder sensor located on the head/carriage unit, then hook the right end while pushing the CR
encoder strip support inwards.
• After replacement of the head/carriage unit, check that the CR encoder strip and PF encoder disk
are free of grease and ink. If they are stained with grease or ink, replace them.
• If you replace the head/carriage unit, make adjustments specified in
Black
Yellow
Cyan
Magenta
Tube/cable guide
Spring
Hook
mark points upwards as shown on
6-51
(Rear)
Tube guide
Sponge
When routing the ink
supply tubes through this
tube guide, do not overlap
them with each other.
marked end is to the right
-
page
6-41.
Chapter 7, Section
Lower cover
(6_46_A)
7.2.
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
