Components On The Engine Unit - Brother DCP130C Service Manual
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
6.1.14 Components on the Engine Unit
(Maintenance unit, Mode switching lever & clutch gear ASSY, Carriage motor, Inner chute
ASSY, Registration sensor PCB, PF encoder PCB, Paper feed motor, Paper pull-in gear shaft,
and Paper pull-in roller holder)
Maintenance unit and mode switching lever & clutch gear ASSY
(1) Remove the three screws from the maintenance unit--two "a" screws from the top and one "b"
screw from the right side.
(2) Take the maintenance unit off the engine unit.
(3) Remove the SF changeover gear, HS changeover gear, and HS gear plate (which is used only
in the early version of machines) from the maintenance unit.
(4) Slide the mode switching lever & clutch gear ASSY outwards to remove it.
(5) Unlatch the switching lever guide from the CR guide rail.
Carriage motor
harness
Tighten these screws
in the order of 1 to 3 .
CR guide rail
(Front)
HS
changeover
SF changeover
gear
gear
1
"a"
2
Switching lever
"a"
guide
PF roller gear R
Cutout
Apply
grease
here.
HS gear
plate*
Thick
Thin
6-58
Apply grease here.
Right hook
Mode switching lever &
clutch gear ASSY
Apply grease here.
3
"b"
Maintenance unit
*Only on the early version of machines
"a": Taptite, bind B M3x8
"b": Taptite, cup S M3x6
Apply
grease
here.
(6_56)
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
