Brother DCP130C Service Manual page 246
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
This chapter describes the maintenance mode which is exclusively designed for the purpose of
checks, settings and adjustments of the machine using the keys on the control panel.
In the maintenance mode, you can update memory (EEPROM: electrically erasable
programmable read-only memory) contents for optimizing the drive conditions of the
head/carriage unit or the paper feed roller and paper ejection roller in the engine unit, if those
units have been replaced, or for setting the CIS scanner area, for example. You can also
customize the EEPROM according to the shipment destination of the machine concerned. In
addition, you can perform operational checks of the LCD, control panel PCB or sensors,
perform a print test, display the log information or error codes, and modify firmware switches
(WSW).
9.1
ENTRY INTO THE MAINTENANCE MODE ................................................................... 9-1
9.2
LIST OF MAINTENANCE-MODE FUNCTIONS ............................................................. 9-2
9.3
USER-ACCESS TO THE MAINTENANCE MODE ......................................................... 9-3
9.4
DETAILED DESCRIPTION OF MAINTENANCE-MODE FUNCTIONS ......................... 9-4
9.4.1
EEPROM Parameter Initialization (Function code 01, 91) .................................. 9-4
9.4.2
Printout of Scanning Compensation Data (Function code 05) ............................ 9-5
9.4.3
ADF Performance Test (Function code 08)......................................................... 9-7
9.4.4
Test Pattern (Function code 09) .......................................................................... 9-8
9.4.5
Firmware Switch Setting and Printout (Function codes 10 and 11) .................. 9-10
9.4.6
Operational Check of LCD (Function code 12) ................................................. 9-15
9.4.7
Operational Check of Control Panel PCB (Function code 13) .......................... 9-16
9.4.8
Sensor Operational Check (Function code 32) ................................................. 9-17
9.4.9
Fine Adjustment of Scanning Start/End Position (Function code 54) ............... 9-18
(Function code 55)............................................................................................. 9-19
9.4.11 Updating of Paper Feeding Correction Value (Function code 58) .................... 9-20
(Function code 63)............................................................................................. 9-26
9.4.14 Alignment of Vertical Print Lines in Monochrome (Function code 65) .............. 9-27
9.4.15 Margin Adjustment in Borderless Printing (Function code 66) .......................... 9-29
9.4.16 Updating of Property Data (Function code 68).................................................. 9-32
9.4.17 Head/Carriage Unit Traveling Speed Check (Function code 69) ...................... 9-33
9.4.18 EEPROM Customizing (Function code 74) ....................................................... 9-34
CHAPTER 9 MAINTENANCE MODE
CONTENTS
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
