Checking Of Cis Travel And Specifying Of Cis Type (Function Code 59) - Brother DCP130C Service Manual
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
9.4.12 Checking of CIS Travel and Specifying of CIS Type (Function code 59)
Function
This procedure allows you to check the movement of the CIS unit integrated in the scanner cover
(scanner unit). The CIS unit travels to the three positions--the white reference film position,
scanning start and end positions.
It also allows you to enter the CIS type (Canon, Rohm, or Lite-On) into the EEPROM on the main
PCB. If you replace the scanner cover or the main PCB, you need to specify the CIS type according
to the procedure given below.
Operating Procedure
-- Check the movement of the CIS unit --
(1) Enter 5 and 9 in the initial stage of the maintenance mode using the / and OK keys.
The "1:MO 2:CO 3:CHG?" appears on the LCD.
(2) To call up the CIS travel menu, enter 1 using the / and OK keys.
(The "3:CHG" is for specifying the CIS type, as described on the next page. The "2:CO" is for
checking scanning clocks at the factory, so do not access it.)
The "LED PWM: " appears on the LCD.
(3) Press the OK key.
The "1:WHT 2:FRT 3:MV" appears.
(4) Enter 3, 1, or 2 using the / and OK keys, then press the OK key.
The CIS unit moves to the scanning end position, white reference film position, or scanning
start position, respectively.
(5) Press the Stop/Exit key, and the CIS unit returns to the home position.
The machine returns to the initial stage of the maintenance mode.
9 - 2 4
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
