Brother DCP130C Service Manual page 348
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
Selector
No.
1
Not used.
Default reduction rate for
2
failure of automatic reduction
during recording
3
Not used.
4
(Do not disturb this selector.)
Minimum ON and OFF
5
duration of ringer signals
effective in distinctive ringing
6
|
Not used.
8
NOTE: Selector 5 is applicable only to the U.S.A. models.
Selector 2:
Default reduction rate for failure of automatic reduction during recording
This selector sets the default reduction rate to be applied if the automatic reduction function fails to
record one-page data sent from the calling station in a single page of the current recording paper.
If it is set to "0," the machine records one-page data at full size (100%) without reduction; if it is set
to "1," the machine records it at 70% size.
Selector 5:
Minimum ON and OFF duration of ringer signals effective in distinctive ringing
The ringer pattern consists of short and long rings, e.g., short-short-long rings. This selector sets the
minimum ON and OFF duration of ringer signals that are required for the machine to interpret ringer
signals as being ON or OFF. This is to prevent components of a ringer pattern from being
misinterpreted due to chattering in distinctive ringing.
The machine monitors ringer signals at 10-millisecond intervals. If the signal is ON, the machine
counts +1; if it is OFF, it counts -1. If the counter increments up to +5 or +13 when this selector is
set to "1" (90 milliseconds) or "0" (130 milliseconds), respectively, the machine interprets the current
signal as being ON.
If the counter returns to zero, the machine interprets the signal as being OFF.
If the Distinctive Ring is set to OFF, this selector is not effective.
WSW31
(Function setting 9) (Not used.)
Function
App. 4-35
Setting and Specifications
0: 100%
1: 70%
0: 130 ms
1: 90 ms
ms: millisecond(s)
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
