Brother DCP130C Service Manual page 353
Hide thumbs
Also See for DCP130C:
- User manual ,
- Software user's manual (155 pages) ,
- Quick setup manual (24 pages)
Table of Contents
Advertisement
Selector
No.
ECP mode*
1
(Not used.)
Recovery from Inactive PC
2
Interface
3
PC Power-off Recognition Time
4
Not used.
Escape from phase C
5
(Not used.)
Extension of incoming calling
signal (CI) frequency band
6
specified by selectors 1 through 4
|
on WSW14
8
(Not used.)
NOTE: Selectors 2 and 3 on WSW36 take effect only when the "Monitoring the PC ON/OFF state" is
enabled with selectors 1 and 2 on WSW46.
Selector 1:
ECP mode (Not used.)
The ECP mode enhances the normal bidirectional communications between the machine and the
connected PC for higher transmission speed.
Selector 2:
Recovery from Inactive PC Interface
If the machine recognizes via the STB signal line that the connected PC is powered off, it will turn
the PC interface outputs Low to protect the PC from hazards that could be caused by weak electric
current accidentally flown from the machine.
This selector determines whether or not the machine should recover from the inactive PC interface to
normal interfacing state upon receipt of data from the PC.
Selector 3:
PC Power-off Recognition Time
This selector sets the time length from when the machine detects the PC powered off until it
recognizes the detected state as power-off.
If selector 2 is set to "0," it is recommended that selector 3 be set to "1"; otherwise, the machine may
mistakenly detect PC powered off.
Selector 5:
Escape from phase C (Not used.)
This selector determines whether or not the machine will escape from phase C when it detects an
RTC (Return to Control) in non-ECM mode or an RCP (Return to Control Partial page) in ECM
mode.
WSW36
(Function setting 14)
Function
App. 4-40
Setting and Specifications
0: ON
1:
0: Disable
1:
0: Normal
1:
0: Yes
1:
No. 6 7 8
0 0 0 :
0 (Ignored)
0 0 1 :
4 (448 Hz)
0 1 0 :
8 (244 Hz)
0 1 1 :
12 (162 Hz)
1 0 0 :
16 (122 Hz)
1 0 1 :
20 (97 Hz)
1 1 0 :
24 (81 Hz)
1 1 1 :
28 (69 Hz)
OFF
Enable
Long
No
*ECP (Enhanced Capabilities Port)
Confidential
Advertisement
Chapters
Table of Contents
Troubleshooting
