Table of Contents
Advertisement
RtP
FENCE TND|CATOR
ADJUSTMENT
(Ftc.
O)
1.
The
rip
fence indicator (6) points to the
measurement scale. The scale shows
the
distance
from the side
of
the fence to nearest
side
of the
blade.
2.
Measure
the actual distance with a rule. lf there
is
a
difference between the measurement
and
the
indicator, adjust the indicator
(6).
3.
Loosen
the screw (7) and slide the indicator to
the
correct measurement on the scale. Tighten
the
screw
and
remeasure with the
rule.
To avoid
injury
from an accidental start, make
sure
the switch is
in
the OFF position and the plug is
not
connected
to
the power source
outlet.
ADJUSTING THE 90" AND
45" POSITIVE
STOPS
(F!G.Q-1, Q-2,
Q-3)
Your saw has positive stops that will quickly
position
the saw blade
at
90" to the table. Make adjustments
only
if necessary.
90"
Stop
1.
Disconnect
the
saw from the power
source.
2.
Turn the blade elevation handwheel and
raise
the
blade
to the maximum
elevation.
Loosen
the blade bevel lock handle
(2)and
move the blade to
the maximum vertical
position.
Tighten
the lock handle
(2).
Place a
combination square on the table
and
against the blade
(1)
to determine
if
the blade
is
90'to
the table. (Fig. Q-2)
lf the blade
is not
90"
to
the table, loosen the
two
set screws (4), located underneath the table
saw,
(Fig.
a-3)with
the hex key, and back off
the
collar..
6.
Loosen the bevel lock knob. Turn the
blade
tilting handwheel to move the blade until it
is
90'
to
the table.
7.
Adjust the collar (5) so
it
contacts the bracket
(3)
when the blade
is
90'
to
the table. Tighten
the
two set screws
(4).
Fig.
Q-1
Fig.
Q-2
45'Stop
1.
With the blade in the upright
90'position,
loosen
the bevel lock knob and
move
the
blade to the
45"
position
as
far as
it
will
go.
2.
Place
the combination square
on
the table
as
shown in
(Fig.a-2)to
check
if
the blade
is
45"
to
the
table.
3.
lf the blade
is not
45'
to
the table,
loosen
the
two
set screws (a) (Fig.
Q-3)with the hex key.
Back-
off
the collar
(5)
then
align
the
blade
45"
to
the
table, adjust the collar (5) so
it
contacts
the
bracket
(3)
.
4.
Retighten the two set screws
(4).
BLADE TILTING POINTER
1.
When the blade is positioned
at
90',
adjust the
blade
tilting pointer
to read
0'
on the scale.
2. Loosen the holding screw, position
pointer
over
0'
and
tighten the
screw.
NOTE: Make
a
trial cut on scrap wood
before
making critical cuts. Measure for
exactness.
Fig.
Q-3
3.
4.
14
Hide quick links:
Advertisement
Table of Contents
