Table of Contents
Advertisement
1.10.2 Internal connectors
1. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the floppy
drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables
with pin 5 plug).
P4P800-X
P4P800-X Floppy disk drive connector
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
This connector supports the provided UltraATA100 IDE hard disk ribbon cable.
Connect the cable's blue connector to the primary (recommended) or secondary
IDE connector, then connect the gray connector to the UltraATA100 slave device
(hard disk drive) and the black connector to the UltraATA100 master device.
1. Follow the hard disk drive documentation when setting the device in master
2. Pin 20 on each IDE connector is removed to match the covered hole on the
3. The hole near the blue connector on the UltraATA cable is intentional.
P4P800-X
P4P800-X IDE connectors
1-18
®
or slave mode.
UltraATA cable connector. This prevents incorrect orientation when you
connect the cables.
®
FLOPPY
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PIN 1
PIN 1
Chapter 1: Product introduction
Hide quick links:
Advertisement
Table of Contents
