Table of Contents
Advertisement
Refer to the audio configuration table below for the function of the audio ports in
2, 4, 6, or 8-channel configuration.
Audio 2, 4, 6, or 8-channel configuration
Port
Headset
2-channel
Light Blue
Line In
Lime
Line Out
Pink
Mic In
Orange
–
Black
–
Gray
–
11. USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports
are available for connecting USB 2.0 devices.
12. USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports
are available for connecting USB 2.0 devices.
13. VGA port. This port is for a VGA monitor or other VGA-compatible devices.
14. External SATA port. This port connects to an external Serial ATA hard disk
drive. To configure a RAID 0, a RAID 1, or a JBOD set, install and external
Serial ATA hard disk drive and an internal Serial ATA hard disk drive to the
SATA connector labeled SATA_RAID or SATA_RAID1.
The external SATA port supports external Serial ATA 3.0 Gb/s devices. Longer
cables support higher power requirements to deliver signal up to two meters
away, and enables improved hot-swap function.
•
Before creating a RAID set using Serial ATA hard disks, make sure that you
have connected the Serial ATA signal cable and installed Serial ATA hard
disk drives; otherwise, you cannot enter the JMicron RAID utility and SATA
BIOS setup during POST.
•
If you intend to create a RAID configuration using this connector, set the
JMicron SATA Controller Mode item in the BIOS to [RAID]. See section
"2.4.6 Onboard Device Configuration" for details.
•
DO NOT insert a different connector to this port.
•
DO NOT unplug the external Serial ATA box when a RAID 0 or JBOD is configured.
15. PS/2 keyboard port (purple). This port is for a PS/2 keyboard.
ASUS P5B-VM DO
4-channel
Line In
Front Speaker Out
Mic In
–
Rear Speaker Out
–
6-channel
Line In
Front Speaker Out
Mic In
Center/Subwoofer
Rear Speaker Out
–
8-channel
Line In
Front Speaker Out
Mic In
Center/Subwoofer
Rear Speaker Out
Side Speaker Out
1-31
Hide quick links:
Advertisement
Table of Contents
