Table of Contents
Advertisement
3.
IDE connector (40-1 pin PRI_EIDE)
The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable.
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device.
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
P5B-VM DO IDE connector
ASUS P5B-VM DO
Drive jumper setting
Cable-Select or Master
Cable-Select
Master
Slave
PRI_EIDE
Mode of
device(s)
-
Master
Slave
Master
Slave
PIN1
NOTE: Orient the red markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
Cable connector
Black
Black
Gray
Black or gray
1-33
Hide quick links:
Advertisement
Table of Contents
