Table of Contents
Advertisement
1. Press the
button once and the driver's door only will unlock.
2. Press the
button again within three seconds and the passenger doors will unlock.
VIOLET/WHITE Arm/Disarm (-) Output (300 mA maximum) (P1/3)
The VIOLET/WHITE wire can be connected to a pager or used to drive a relay when adding extra sirens. This wire
pulses to ground (-) when the siren chirps and will stay at ground for as long as the siren is sounding.
GREY/BLACK Channel 5 Accessory (-) Output (P1/4)
The GREY/BLACK wire can be programmed to provide a PULSED 0.75 second ground (-) or LATCHED output. If the
remote control button is continuously pressed when programmed for a PULSED output, the signal will stay at
ground for as long as the button is held. If the remote control button is pressed when programmed for a LATCHED
output, the signal will stay at ground until such time as the button is pressed a second time.
BROWN Coded Link for Siren (P1/5)
The BROWN wire is the siren's data connection. This wire controls whether the siren should chirp or sound, etc.
Connect the BROWN wire to the BROWN siren wire.
NOTE: Do not connect anything other than the system siren to this wire or damage may occur.
RED/WHITE (P1/6)
The RED/WHITE wire provides a 0.75 second ground (-) output when the alarm is disarmed only. This is ideal for
boot release. If the remote control button is continuously pressed, the signal will stay at ground for as long as
the button is held.
NOTE: Most boot releases are switched positive and require an additional relay.
2 BLACK Screened Wires Pre-Wired to Ultrasonic Sensors (P1/7, 8, & 9)
These wires are to be plugged into the two ultrasonic sensors.
2 WHITE & BLACK with WHITE TAG Indicator Lights (P1/10, 11, & 12)
1. If the indicator lights are positive trigger, connect the BLACK wire with WHITE tag to the constant positive
(+) battery terminal through the 20 amp fuse provided.
NOTE: Do not connect the BLACK wire with WHITE tag to the control unit BLACK wire with RED tag.
2. If the indicator lights are negative (-) trigger, connect the BLACK wire with WHITE tag to the control unit
BLACK wire with GREEN tag.
3. Connect the WHITE wires to the left and right indicator light wires on the vehicle.
On-Board Door Lock Relays (P1/13-P1/18)
For installation instructions, see Door Lock Diagrams beginning on page 13.
©
2002 Directed Electronics, Inc.
7
Advertisement
Table of Contents
