Table of Contents
Advertisement
GREY Prewired to Valet Switch (P2/5)
The GREY wire is switched to ground whenever the valet switch is pressed.
ORANGE Armed (-) Output (P2/6)
The ORANGE wire will provide a ground (-) output for as long as the alarm is Armed. It does not provide a ground
when the system is Passive Immobilised or Disarmed.
BLUE Bonnet Trigger Input (P2/7)
1. Locate the vehicle bonnet pin switch that shows ground when the bonnet is opened.
2. Connect the BLUE wire to the BLUE siren wire. Connect the bonnet switch to the BLUE wire exiting the siren
harness at the siren.
3. If the vehicle does not have a bonnet switch, install a pin switch and connect it to the BLUE wire exiting
the siren harness at the siren.
GREEN Door Trigger/Interior Light Illumination (P2/8)
The system has a negative door trigger input. If the vehicle door trigger is negative (-) switching, connect the
alarm GREEN wire to the vehicle door trigger wire. For vehicles that have a positive door trigger, a relay will need
to be added to provide the GREEN wire with a negative when the door is open.
NOTE: When the alarm is remote disarmed, the GREEN wire will provide a negative output to turn
the interior lights on.
BLACK with GREEN TAG, BLACK with RED TAG Power and Ground Connections (P2/9 & 10)
CAUTION: Do not plug in the system fuses until the final step below.
1. Connect the BLACK wire with RED tag to one of the supplied fuse assemblies.
2. Connect the BLACK wires with GREEN tags to separate chassis ground locations.
3
Connect the empty fuse assembly(s) to the positive battery post.
NOTE: This wire must be a minimum of 14 gauge.
©
2002 Directed Electronics, Inc.
9
Advertisement
Table of Contents
